Questioning – an Effective Strategy for Improving Learning and Performance in Personal & Process Safety. James C. Lefler, CSP and David A. Jones – JCL Safety Services LLC and JCL Risk Services
Poll Ended
Session Feedback 29
Prevent Cracks in Heat Exchanger Channel Flanges. Oskar Cortez, Manager, Advanced Sealing Technologies - AFGlobal Corporation
Poll Ended
Session Feedback 28
New Impeller Stage Design. Keith Schuster - Dresser Rand
Poll Ended
Session Feedback 27
Catalyst Performance
Poll Ended
Session Feedback 26
Technology for Expansion & Efficiency Opportunity for Nitrogen Plants Joric Vital Ed Kuenz Nalco Water
Poll Ended
Session Feedback 25
Taking the Guesswork out of Reformer Tube Creep Rupture Life. Timothy Till, P.E. Principal Consultant, Process Integrity Optimization Engineering; Darrell W. Meinen, Service Line Director – Reformer Care – Quest Integrity.
Safety Improvements, higher level standards / philosophies. Relief Devices & Systems - Reset Valves vs. Rupture Discs - Parallel Valves - Relief System Studies
Poll Ended
Session Feedback 18
Large Turnaround Planning & Execution
Poll Ended
Session Feedback 17
An Innovative Internet and External 360° Reformer Tube Inspect Technology. Thomas Fortinberry, Executive V.P. – Reformer Services LLC.
Poll Ended
Session Feedback 16
Advances in Industrial Cooling Water Treatment. Brad Buecker and Raymond Post, P.E. – Chemtreat
Poll Ended
Session Feedback 15
103JAT Steam Chest Upgrade. Keith Schuster - Dresser Rand.
Poll Ended
Session Feedback 14
What is your decision process when process leaks develop? Tightening flanges, Bonnets, etc. Leak Repair
Poll Ended
Session Feedback 13
What Methods are being used to improve reliability of pump systems in Ammonia Plants?
Poll Ended
Session Feedback 12
JSA's What is an effective JSA workflow & involvement?
Poll Ended
Session Feedback 11
For Ammonia Plants Retrofitted with a flare system - Was it designed to be one flare for the front & back end or split into two separate flares? Other flare related questions.
Poll Ended
Session Feedback 10
Equipment Spareability Strategy - Run both or swap when needed? Discussion of Pumps
Poll Ended
Session Feedback 9
Oil Fowling in Syn Loop - chillers - What do producer do to remove and prevent it.
Poll Ended
Session Feedback 8
How to improve operator technical knowledge and overall accountability for plant operations?
Poll Ended
Session Feedback 7
Has anyone replaced the 101 C's with a different design than the bayonet & scabbard tube design?
Poll Ended
Session Feedback 6
Besides RV's / rupture disks - how are valves assigned a car seal or not? In terms of safety, critical valves, process upsets, and environmental.
Poll Ended
Session Feedback 5
Adding rundown tanks to 101J, 103J, 105J. Who has done it? How? New larger reservoir? Or satellite reservoir to handle potential overflow?
Poll Ended
Session Feedback 4
What is the typical density / consistency of carbomate and how does this affect carbomate pumps?
Poll Ended
Session Feedback 3
Primary reformer catalyst increased pressure drop: issues with mitigations for dP increase due to plant cycling
Poll Ended
Session Feedback 2
Anyone doing PWHT on new CS Piping for anhydrous NH3. Anyone aware of non-PWHT carbon steel cracking in anhydrous NH3 with possibility of O2 in the process